Nut, Curved Bottom, Blank 1 3/4", 44.45 mm, Bone for S or T Type Guitars
Custom Shop, pre-shaped, unslotted bone blank
Cut and shape to your specific needs from 7.25" radius to 12" radius. 1 5/8" to 1 3/4"
6 or 7 string application
Fits most nut shelf cuts for S or T Guitars.
Save time and cost trying to shape nut to curves.
Specifications
9.5" Radius
Natural Bone
Unslotted, cut your own string spread string locations.
Non-Handed for 6 or 7 string guitar setup
Overall width 1.754" (1 3/4") (44.45mm)
Natural Shaped Bone nut.
Overall width is 3.3mm (.130"or slightly over 1/8")
Overall material height (at center) is .236" (15/64" or 6mm)
Overall height is .276" ( slightly over 17/64" or 7.0mm)
Upper radius (string) is approximately 9.5"
Bottom edge is curved
This product is a shaped natural bone nut.
![]()
Please note: due to the variations in guitar setups, you will need to sand or adjust this part to fit your specific guitar. There are a number of radius and bottom setups, widths and other details that vary from guitar manufacturers, if you have questions, please email us, we will try to answer your questions as to fit, we cannot guarantee fit for specific guitars, there are so many variations from year to year and model to model.
You will need to adjust this product to fit your specific application.
This Product may contain a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm.
For more info go to www.P65Warnings.ca.gov
