Questions? Call Us!
18" LengthTwo Way Spoke Wheel Dual Action adjustment with steel adjustment tool (3 15/16")Uses a set of dual screw threads (one at nut, one at end)3 15/16" steel adjustment rod for headRod is wrapped in blue shrink wrap to allow for gluing. (Note do not remove blue wrap, it is a functional part of the rod design).
Requires:6mm - 1/4" wide slot .36" (9.2mm) depth (slightly more than 23/64") The cut area for the spoke wheel will depend on your preference. See drawing. a. In the drawing we are showing the cut .81" (20.5mm or 13/16") Deep (top to bottom), . b. 25" (6.35mm or 1/4") into the neck end horizontally c. .951" (25mm or 61/64") wide across the heel. 18" length (varies slightly due to construction 17 31/32" - 18") Rod length is tip to end of wheel.
A PDF Version of the drawing for this is available, please email us for information.PLEASE NOTE: We recommend you bench test the rod prior to installation in your neck. While we do not have many issues with the performance of this rod, but it is a good idea to check the rod prior to installation. Bench testing can be down by placing each end of the rod in a vise and moving the rod in a normal range of motion and beyond to check the rod. After installation the rod can be very difficult to remove or repair. We test all rods here in the US, but we do suggest this additional step to insure the rod is working correctly prior to placement in the neck.Warranty for this rod is limited to replacement of the rod.or a refund on the product itself. Bitterroot Guitars is not responsible for repair or replacement of any guitar or neck due to installation or product failure. Warranty is limited to replacement or refund of the rod itself and the original cost of the rod. Any modifications to the rod void this warranty. Please contact us if you have an issue with any of our rods.