Questions? Call Us!
17 1/4" Length (varies slightly due to construction 17 1/4" - 17 3/8") Rod length is tip to end of nut.Two Way Adjustment4mm Allen key headbody is wrapped in blue shrink wrap to allow for gluing.
Works very well for heel mounted nut, also can be used for headstock setup or tilt back headstock
Requires:1/4" wide slot 3/8" depth (approximate, actual is .369" allow for adjusting)Cut for nut area is 1.75" long by .425" (about 7/16" total top to bottom)Wrapped two way adjustable rod
17 1/4" overall lengthSingle Rod in PackageWe have drawings available for this application, please contact us for additional information.PLEASE NOTE: We recommend you bench test the rod prior to installation in your neck. While we do not have many issues with the performance of this rod, but it is a good idea to check the rod prior to installation. Bench testing can be down by placing each end of the rod in a vise and moving the rod in a normal range of motion and beyond to check the rod. After installation the rod can be very difficult to remove or repair. We test all rods here in the US, but we do suggest this additional step to insure the rod is working correctly prior to placement in the neck.Warranty for this rod is limited to replacement of the rod.or a refund on the product itself. Bitterroot Guitars is not responsible for repair or replacement of any guitar or neck due to installation or product failure. Warranty is limited to replacement or refund of the rod itself and the original cost of the rod. Any modifications to the rod void this warranty. Please contact us if you have an issue with any of our rods.This Product may contain a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more info go to www.P65Warnings.ca.gov