Audio Style Potentiometer for applying resistance to audio circuit A tapered logarithmic Audio Pot Quarter Size .934" (approximately 15/16" diameter 23.5mm) Overall height 1.197" (1 13/64" 30.3mm) 6mm Split shaft Shaft is 24 spline shaft Overall shaft thread length is 11/64" Includes one nut and washer per pot
Body Depth .39" (25/64" or 10mm) Shaft Rotation 300 degree
Tolerance: 750 VDC Power Rating: 1/4 watts @ 55°C (Resistance above 100K ohms) Operating Temperature: -10C to +80C Solder Heat Resistance: 260 degree for 5 seconds
Manufacture: CTS "A" Potentiometer is a tapered audio pot, used mainly in volume or tone control.
Sold in each, also available in other combinations, please email us for assistance.
Please note: These do NOT fit our 6mm push on 18 spline knobs that are 6mm
6mm split shaft (24 spline) x 0.375 high (3/8")
Mounting hole required
NOTE: You will need to solder this in to your circuit, knowledge of solder and tools will be needed to use this item.
This Product may contain a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more info go to www.P65Warnings.ca.gov
The trademarks, service marks or registered trademarks are those of their respective owners.
The parts on this site are made by or for Bitterroot Guitars.
These parts do not originate from the original OEM manufactures unless specifically identified as such.
Fender®, Strat®, Stratocaster®, Esquire®, Telecaster®, Tele®, Jazzmaster®, Jaguar®, Mustang®, P-Bass®, and J-Bass® are registered trademarks of Fender Musical Instruments Corporation.
Gibson®, Epiphone®, Les Paul®, S.G.®, Flying V®, ES-175®, ES-335® and P-90® are registered trademarks of Gibson Guitar Corporation
Kluson® is a registered trademark of W.D. Music Incorporated
LM®, SURELOCK® are registered trademarks of LM Products Company Incorporated
Lock-It® is a registered trademarks of Musical Distributors Group
Martin® is a registered trademark of Martin Guitar Company
S.I.T. Strings® is a registered trademark of S.I.T. Strings Company,